Free Exit & Safety Loops

Free Exit & Safety Loops
Vehicular Loops are installed in the ground and are used to control gate operator when vehicle passes over the top of the loop.
3 types of loops:
1. Free exit/Safety Loop (Inside Loop)
--To open a gate upon exit. This also gives vehicle safety and reverses the gate to prevent gate from closing on vehicle upon exit. Requires one detector and one loop kit. This is the inside wire loop installation.
2. Safety / Reverse Loop (Outside Loop):
--To reverse a gate upon entry. Prevents a gate from closing on vehicle upon entry. When gate is in fully closed position this detector does not open gate. The gate remains closed. Requires one detector and one loop kit. This is the outside wire loop installation.
3. Shadow / Center Loop (Loop under path of swinging gate):
--To hold open and not allow a swinging gate to close from the full open position. For swinging gates only. Not for slide gates. Prevents gate from closing on short length vehicles when vehicle is positioned between the inside and outside safety wire loops. Requires one detector and one loop kit. This is the center wire loop installation and loop is placed under the path of the swinging gate unlike all other loop installations.
Helpful Information:
--Loop Sizes & Loop Characteristics
--Loop Wire Installation

Products

  •  per page
LOOPdetectorSL orCSW
SKU: 309AELD
Elite Plug-in Loop Detector
Our price: $149.00
Quantity

LoopDt,CSL,CSW24,LA5
SKU: 309LOOPDETLM
Plug In Loop Detector For LA500 Operators
Our price: $149.00
Quantity

DSP-10LV UNIV DETECT
SKU: 306DSP-10LV
Vehicle Loop Detector by Diablo Controls
--Model: DSP-10 Series
--Plug and play
--Works on any in-ground inductive loop from 20 to 2000 microhenries
--Can be easily changed to fail safe or fail secure mode in the field.
--Advanced filtering technology for superior noise tolerance.
--The DSP-10-LV is protected from damage if plugged into a higher voltage. No need to change a fuse or reset a circuit breaker, simply plug the detector into the proper voltage and it works.
--Separate Power/Fail and Detect LEDs.
--Compact size with industry standard 11-pin connector in a small plastic case
--Power Supply Required: DSP-10-LV = 10 to 30 volts AC or DC

Requires Wiring Harness (Not Included - SKU: 306CBL005)
Our price: $169.00
Quantity

DSP-10 WIRE HARNESS
SKU: 306CBL005
Loop Harness For Diablo Control DSP-10
Our price: $13.00
Quantity

4x8'-60'leadPAVEover
SKU: 306PL
Pre-Formed Loop (4'x8')
Our price: $101.99
Quantity

500' ROLL LOOP WIRE
SKU: 700356557
Loop Wire - 500' Roll
Our price: $59.00
Quantity

  •  per page