This low powered vehicle detector is perfect for solar powered applications!
Automatically adjusts its sensitivity level when used on different sized loops.
Covered by United States patent number US 7,132,959 “Non-Interfering Vehicle Detection”.
LED Indicators: The green Power LED blinks once per second to indicate the detector is operating and powered. The red Detect LED will turn on when a vehicle is over the loop detection area.
Loop or Wire Failures: In the case of a loop circuit
failure, the green LED flashes slowly (twice per second) for an open
loop circuit failure. The green LED will flash fast (10 times per
second) to indicate a shorted loop circuit.
Fail Safe vs Fail Secure Info: A fail safe detector will output “detect” when the loop circuit is failed. This is always useful on a safety loop. On the free exit loop this will keep the gate open until the situation is fixed. This is useful in applications where it is important to allow traffic flow to continue. A fail secure detecor will never output “detect” when theloop circuit is failed. This will keep the gate closed. This is useful in high-secure areas or installations where containment is needed. The DSP-7 is a fail safe detecor. Note: Never use a fail secure detector on a safety loop.
Power: This detector is powered with 10 to 30 volts AC or DC. Approximately 1 mA current. The relay contacts are rated at 1 amp maximum.
Connector: Removable 7-pin terminal block.
Pin assignments (from left to right) are shown below:
1: Relay Normally Closed (NC) – contact opens for detect
2: Relay Common
3: Relay Normally Open (NO) – contact closes for detect
4: Power common
5: Power in (10 to 30 Volts AC or +DC)
6: Loop
7: Loop
Size: Height: 1.52″ Width: 2.9″ Depth: 1.56″
Operating Temperature: -35°F to 165°F (-37°C to 74°C)
There are no reviews yet so why don't you use the form here and be the first to submit a review?