DSP-10LV DETECTOR 10v-30v AC/DC

Vehicle Loop Detector by Diablo Controls

--Model: DSP-10 Series

--Plug and play

--Works on any in-ground inductive loop from 20 to 2000 microhenries

--Can be easily changed to fail safe or fail secure mode in the field.

--Advanced filtering technology for superior noise tolerance.

--The DSP-10-LV is protected from damage if plugged into a higher voltage. No need to change a fuse or reset a circuit breaker, simply plug the detector into the proper voltage and it works.

--Separate Power/Fail and Detect LEDs.

--Compact size with industry standard 11-pin connector in a small plastic case

--Power Supply Required: DSP-10-LV = 10 to 30 volts AC or DC



Requires Wiring Harness (Not Included - SKU: 306CBL005)



--Specification Sheet

--Product Manual

--Loop Sizes & Loop Characteristics

--Loop Wire Installation



3 types of loops:

1. Free exit/Safety Loop (Inside Loop)

--To open a gate upon exit. This also gives vehicle safety and reverses the gate to prevent gate from closing on vehicle upon exit. Requires one detector and one loop kit. This is the inside wire loop installation.

2. Safety / Reverse Loop (Outside Loop):

--To reverse a gate upon entry. Prevents a gate from closing on vehicle upon entry. When gate is in fully closed position this detector does not open gate. The gate remains closed. Requires one detector and one loop kit. This is the outside wire loop installation.

3. Shadow / Center Loop (Loop under path of swinging gate):

--To hold open and not allow a swinging gate to close from the full open position. For swinging gates only. Not for slide gates. Prevents gate from closing on short length vehicles when vehicle is positioned between the inside and outside safety wire loops. Requires one detector and one loop kit. This is the center wire loop installation and loop is placed under the path of the swinging gate unlike all other loop installations.