DETECTOR,OMNI BOARD

--For Elite CSW200 and SL3000 models

--Requires loop wire or pre-made loop to complete setup.(not included)

--Plug-In Loop Detector for use with Omni Control Board.

--They are for with the Elite commercial gate operators for Exit Loop, Center Loop, and Safety Loop, depending on the machine and application.

--Manual

--Loop Sizes & Loop Characteristics

--Loop Wire Installation



3 types of loops:

1. Free exit/Safety Loop (Inside Loop)

--To open a gate upon exit. This also gives vehicle safety and reverses the gate to prevent gate from closing on vehicle upon exit. Requires one detector and one loop kit. This is the inside wire loop installation.

2. Safety / Reverse Loop (Outside Loop):

--To reverse a gate upon entry. Prevents a gate from closing on vehicle upon entry. When gate is in fully closed position this detector does not open gate. The gate remains closed. Requires one detector and one loop kit. This is the outside wire loop installation.

3. Shadow / Center Loop (Loop under path of swinging gate):

--To hold open and not allow a “swinging gate” to close from the full open position. For swinging gates only. Not for slide gates. Prevents gate from closing on short length vehicles when vehicle is positioned between the inside and outside safety wire loops. Requires one detector and one loop kit. This is the center wire loop installation and loop is placed under the path of the swinging gate unlike all other loop installations.