MAGNETOMETER DETECT W/ 75' LEAD IN PROBE

DSP-14
The DSP14 system is designed to be an accurate, reliable, and
easy to install detection system. The system is comprised of two
parts, a master unit (DSP-14M) and a sensor (DSP-14S). The
advanced sensor’s small size and high sensitivity make it ideally
suited to vehicle detection applications.
The DSP-14 sensor can be installed using a single saw cut and a
single 1” core hole. The sensor is potted in epoxy to provide
durability and small enough that it can be placed in the cored hole.
Using a three-axis magnetometer sensor eliminates any concerns
about the orientation of the sensor during installation.
The DSP-14 system can hold vehicle detection for an indefinite
period of time. It can even remember vehicle detections through
power outages. Even if a vehicle parks in the detection zone while
power is removed, when power is restored, the detector will sense
that there is now a vehicle in the detection zone. This gives you
an extra level of safety not available with other detection systems.
The master has two selectable output configurations. In the
presence mode, the output is active the entire time a vehicle is in
the detection zone. In the pulse mode, the output will activate for
a short period of time when the vehicle movement is detected in
the detection zone. After two seconds the detector will internally
reset and be ready to output another pulse when vehicle movement
is detected.
Fail-safe or Fail-secure operation is selectable for the output
operating in the presence mode. In the pulse mode the output is
always fail-secure.
The master provides nine selectable sensitivity settings that allow
the user to fine tune the system’s detection zone to the installation.
The diagnostics mode allows the technician to view the last fault
that occurred within the last seven days or since the last detector
reset. Whichever is shorter.